Configuration Wizard
- The 'First Run' configuration wizard lets you configure your first network scan.
- You'll choose the IP range, enable/disable workgroup scans and provide admin credentials.
- Click 'Wizard' on the menu bar to start the wizard at any time.
Step 1 - Enter the IP Range
NAT identifies the network on which it is installed and populates the 'Start IP Address' and 'End IP Address'
You can change these addresses if required.
Step 2 - Enable Domain/Workgroup Scans
- NAT automatically identifies the workgroup or domain which your computer is connected to:
- Leave 'Enable scanning Workgroup/Domain:' selected to scan your current network.
|
Tip: You can enable domain/workgroup scanning at any time. See Network Management for more details. |
Step 3 - Admin
Credentials
- The next step is to provide login details of an admin account on the target network. This will allow NAT to scan the endpoints on your network:
- Enter the username and password of the network administrator in the respective fields and click 'Finish'.
- 'Skip this step' - Choose if you want to provide admin credentials later.
- You can add admin accounts later by clicking the 'Credentials' button in the top-menu. See Credentials Management for more details.
- Click 'Finish' to finalize the configuration.